Work on new and existing energized (hot) electrical circuits is prohibited until all power is shut off and grounds are attached.
An effective Lockout/Tagout system is in place.
Frayed, damaged or worn electrical cords or cables are promptly replaced.
All extension cords have grounding prongs.
Protect flexible cords and cables from damage. Sharp corners and projections should be avoided.
Use extension cord sets used with portable electric tools and appliances that are the three-wire type and designed for hard or extra-hard service. (Look for some of the following letters imprinted on the casing: S, ST, SO, STO.)
All electrical tools and equipment are maintained in safe condition and checked regularly for defects and taken out of service if a defect is found.
Do not bypass any protective system or device designed to protect employees from contact with electrical energy.
Overhead electrical power lines are located and identified.
Ensure that ladders, scaffolds, equipment or materials never come within 10 feet of electrical power lines.
All electrical tools must be properly grounded unless they are of the double insulated type.